• 2.4g Direct Plug-In Module Xh-Nf-01 Built-In Antenna 100mw Power Spi Interface Iot Module
  • 2.4g Direct Plug-In Module Xh-Nf-01 Built-In Antenna 100mw Power Spi Interface Iot Module

2.4g Direct Plug-In Module Xh-Nf-01 Built-In Antenna 100mw Power Spi Interface Iot Module

stars, based on ( 0 )reviews
$1.00 piece
997items available
  • XH-NF-01 is a 200mW power 2.4G wireless module with high airspeed (up to 2Mbps), SPI interface, and integrated hardware module for high-performance, high stability, high cost performance, good spectrum test characteristics, small Volume, using all industrial grade components.
  • XH-NF-01 can be widely used in various Internet of Things applications, suitable for wireless mouse and keyboard, wireless remote control, somatosensory equipment, active RFID, NFC, low-power self-organizing network wireless sensor network nodes, etc. The ideal solution.
  • The XH-NF-01 is packaged in DIP-8. It can be quickly connected to existing products, whether it is for learning or mass production. It can be directly inserted and removed without welding. It is very convenient to use.
Product parameters:
  • DIP-8 ultra-small package with built-in 2.4G antenna, compact size and easy to use
  • Supports six channels of data reception
  • Supports general modulation methods such as GFSK/FSK
  • Supports 2Mbps/1Mbps/250Kbps data rate
  • Multi-frequency point: 126 frequency points to meet the needs of multi-point communication and frequency hopping communication
  • Internally integrated high PSRR LDO
  • Wide supply voltage range: 2.0V~3.6V
  • Average emission current as low as 110mA
  • Receive sensitivity: -96dBm@250kbps
  • Maximum transmit power: +7dBm
  • 4-wire SPI interface with speeds up to 10MHz
  • Internally integrated intelligent ARQ baseband protocol engine
  • Transceiver data hardware interrupt output
  • Support 1bit RSSI output
  • Low application cost: SI24R1 integrates all high-speed signal processing parts related to RF protocol, such as: automatic retransmission of lost data packets and automatic generation of response signals, etc. The SI24R1 SPI interface can be connected with the hardware SPI port of the microcontroller or with the microcontroller I. /O port for simulation, internal FIFO can interface with a variety of high and low speed microprocessors, easy to use low-cost microcontroller.
  • Easy to develop: Since the link layer is fully integrated on the module, it is very easy to develop. Automatic retransmission function, automatic detection and retransmission of lost data packets, retransmission time and number of retransmissions. Software control automatically stores the packet auto-answer function without receiving the response signal. After receiving valid data, the module automatically sends a response. Signal, no need to separately program carrier detection - fixed frequency detection built-in hardware CRC error detection and point-to-multipoint communication address control packet transmission error counter and carrier detection function can be used for frequency hopping setting can simultaneously set six receiving channel addresses, which can be selective Open the receiving channel standard pin DIP 2.54mm pitch interface for easy embedded applications.




Recent Reviews